Operators Manual

24 - English
3. INSTALLATION
Joining the boundary wire
If the boundary wire is not long enough and needs to
be spliced: Use original solderless coupler. It is
waterproof and gives a reliable electrical connection.
To splice: Insert both cable ends in the coupler. Now
press down the button on top of the connector fully.
Use a pair of pliers or the like, as the button on the
connector is difficult to press down by hand.
3.5 Connecting the boundary wire
Connect the boundary wire to the loop
generator/charger:
1. Place the cable ends in the connector:
Open the connector.
Place the wire in the connector grip.
2. Press the connector together using a pair of
pliers. Press until you hear a click.
IMPORTANT INFORMATION
Twisted cables, or a screw terminal
(chock-block), insulated with insulation tape
is not a satisfactory splice. Soil moisture will
cause the conductors to oxidise and after a
while result in a broken circuit.