Operators Manual
English - 25
3. INSTALLATION
3. Cut off any surplus boundary wire. Cut 1 - 2 cm
above respective connectors.
4. Attach the connector to the contact pin on the
loop generator/charger.
3.6 Checking the installation
Check the loop signal by looking to see what
indication the green LED on the loop
generator/charger is giving.
• Steady light = the signal is okay.
• Flashing once every other second = break in the
loop and no signal found.
• Flashing twice every other second = weak signal.
This may be due to the boundary wire exceeding
350 metres or that the cable is damaged. If the
mower works, it is not a problem.