Operators Manual

ELECTRICALSYSTEMS

IGNITION SWITCH

The ignition switch is located in different areas depend-

ing on trimmer model. For 26 RLC and 32 RLC models

the switch is located on the engine cover. For 26 LC and

32 LC models the switch is located either on the engine

cylinder cover or next to the throttle trigger mounted on

the trimmer shaft.

STEPS 1 THRU 4

ARE FOR LC MODELS ONLY

.- I

1. Remove screw

housing.

2. Remove the PI

Iand

Iillip

nut from throttle trigger

screw from switch cover.

3. Disconnect wires from underside of starter housing

as shown.

4. Carefully pull out wiring assembly and replace as

necessary.

5. On RLC models, remove clutch housing, clutch

and starter housing assembly as shown in starter

repair section.