Operators Manual

CLUTCH REMOVAL & INSTALLATION
I
NEVER STARTTHE ENGINE WITH
THE CLUTCH DRUM HOUSING
ASSEMBLYREMOVED. IF YOU DO
CLUTCH SHOES WILL SEPARATE
FROM THE SPIDER AND CAN
CAUSE SERIOUS INJURY.
NOTE
Refer
.
‘:
to throttle cable sec
steps 1 thru 3.
1. Disconnect spark plug wire.
2. Remove spark plug.
3. Insert piston stop part number 5025033-01
into spark plug opening and tighten.
NOTE:
For the following steps (4 thru 6)
refer to Throttle Cable section.
4. Remove screw and nut from throttle trigger
housing.
5. Hold throttle trigger away from foam grip and
remove barrel end of throttle cable from
throttle trigger.
6. Carefully pull throttle cable out of foam grip.
7. Remove the 4 clutch shroud screws with a
4mm hex wrench.
25
.