Operators Manual

:LUTCHSYSTEM
STARTER ROPE INSTALLATION
NOTE:
Always wear safety glasses when working
on the starter assembly.
1. Place starter pulley back into the starter housing,
making sure pulley interlocks with starter spring.
2. Reinstall starter pulley retaining tab(s).
3. Hand turn starter pulley 8 revolutions clockwise
on 32 R models and counterclockwise on
26 RLC and LC models.
4. Turn the pulley counterclockwise two full
revolutions on 32 R, clockwise on 26 LC,
RLC and 32 RL.
5. Align notch on pulley with the housing notch
next to the retaining tab.
—
6. Insert a center punch into the hole that the
notches form, to hold pulley in position.
7. Use a 1.5mm diameter, 42 inch long piece of
Husqwmna replacement rope.
8. Move at least 3m (10 feet) away from fuel tank
with replacement rope. With a match, melt both
ends of replacement rope to prevent fraying.
9. Insert rope through pulley hole and then through
rope eyelet in housing.
10. Pull rope through eyelet, until about 6 inches of
rope remains on outside of pulley.