Operators Manual

CYLINDER.PISTON&RING
)
CAUTION
THE MUFFLER
IS HELD TO THE
CYLINDER BY
TWO SPRINGS.
ALWAYSWEAR
SAFETY GLASSES
WHEN
REMOVING
MUFFLER
RETAINING
SPRINGS.
CYLINDER & PISTON
REPLACEMENT
1.
Remove spark plug.
2. On RLC units refer to crankshaft and
~~
reed valve replacement section. On
I
LC units remove top cover.
,,.-’”
““+
4.
Remove muffler by releasing
muffler retaining springs
with pliers.
Using a 5mm hex wrench part
number 5025057-01 remove two
cylinder head bolts.
Slide cylinder off unit to
expose piston.
6. Using a needle nose pliers, remove wrist
pin retaining clips as shown, from one
side of piston. Note piston position. Pis-
ton locating pin faces right side of unit
from operators position.
7. Using adrift, lightlytap wrist pin outand
remove piston and wrist pin bearing.
8. To reinstall piston reverse steps 1thru 8.