Operators Manual

CRANKCASE
REED VALVE REPLACEMENT
1. Remove engine from drive shaft and
starter (see starter section 1 thru 8).
2. Remove top cover on LC models.
3. Remove carburetor (see throttle cable removal
section 1 thru 5).
~ 4. Remove six 4mm hex head screws at back of
carburetor area as shown.
~ 5. Separate engine from back plate housing
as shown.
~ 6. Remove two phillips head screws retaining
reed valve assembly.
7. Replace reed valve and reinstall reed valve
back plate with Phillips head screws.
NOTE:
Be sure when reinstalling reed valve back
plate that the bend faces outward.