Operators Manual

TRIMMERHEAD
INSTALLATION & REMOVAL
I
r
1.
2.
Place dust cap over hex nut located on end
of drive shaft housing.
I
Once inplacehold dustcap with awrench to prevent
arbor shift from turning on 26 RLC and 26 LC
units. On straight shaft units use the locking pin to
hold dust cap from turning.
3. Thread trimmer head onto arbor shaft by rotating
head (clockwise for curve shaft units, counter-
clockwise for straight shaft units) against dust
cap and tighten by hand.
4. To remove trimmer head reverse steps (
INSTALLING SPOOL
WITH LINE
-
thru 3 ).
Use only Husqvarna pre-wound spools with 2mm (.080
inch) diameter line. (Use of anything other than
Husqvarna spools or line may result in breakage, line
welding and improper line feed.)