Operators Manual
Table Of Contents
- Symbols
- Contents
- Note the following before starting:
- Dear Customer,
- Important
- Personal protective equipment
- Machine¢s safety equipment
- Cutting equipment
- Fitting the handlebar
- Transport position, handlebar
- Assembling the cutting equipment
- Fitting a blade guard, grass blade and grass cutter
- Fitting the blade guard and saw blade
- Fitting a trimmer guard and Superauto II 1” trimmer head
- Fitting other guards and cutting attachments
- Adjusting the harness and brush cutter
- Standard harness
- Fuel handling
- Fuel
- Check before starting
- Starting and stopping
- General working instructions
- Carburettor
- Muffler
- Cooling system
- Spark plug
- Air filter
- Maintenance schedule
- Technical data
- EC-declaration of conformity (Applies to Europe only)
STARTING AND STOPPING
20 – English
Primer bulb: Press the air purge repeatedly until fuel
begins to fill the bulb. The bulb need not be completely
filled.
Warm engine
Ignition: Set the stop switch to the start position.
Choke: Put the choke in working position.
Primer bulb: Press the air purge repeatedly until fuel
begins to fill the bulb. The bulb need not be completely
filled.
For throttle handles with a start throttle
lock:
Set the throttle to the start position by first pressing the
throttle lockout and the throttle trigger, then pressing the
start throttle button (A). Then release the throttle lockout
and the throttle trigger, followed by the start throttle
button. The throttle function is now activated. To return the
engine to idle, press the throttle lockout and throttle
trigger again.
Starting
Hold the body of the machine on the ground using your
left hand (CAUTION! Not with your foot!). Grip the starter
handle, slowly pull out the cord with your right hand until
you feel some resistance (the starter pawls grip), now
quickly and powerfully pull the cord.
Never twist the
starter cord around your hand.
Repeat pulling the cord until the engine starts. When the
engine starts. return choke control to run position and
apply full throttle; the throttle will automatically disengage
from the start setting.
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.
Stopping
Stop the engine by switching off the ignition.
OIL
OIL
!
WARNING! When the engine is started
with the choke in either the choke or
start throttle positions the cutting
attachment will start to rotate
immediately.