Operators Manual
Table Of Contents
- Symbols
- Contents
- Note the following before starting:
- Dear Customer,
- Important
- Personal protective equipment
- Machine¢s safety equipment
- Cutting equipment
- Fitting the handlebar
- Transport position, handlebar
- Assembling the cutting equipment
- Fitting a blade guard, grass blade and grass cutter
- Fitting the blade guard and saw blade
- Fitting a trimmer guard and Superauto II 1” trimmer head
- Fitting other guards and cutting attachments
- Adjusting the harness and brush cutter
- Standard harness
- Fuel handling
- Fuel
- Check before starting
- Starting and stopping
- General working instructions
- Carburettor
- Muffler
- Cooling system
- Spark plug
- Air filter
- Maintenance schedule
- Technical data
- EC-declaration of conformity (Applies to Europe only)
MAINTENANCE
English – 27
excess oil out of the filter inside the plastic bag and pour
off the excess before fitting the filter to the machine. Never
use common engine oil. This would drain through the filter
quite quickly and collect in the bottom.
Bevel gear
The bevel gear is filled with the right quantity of grease at
the factory. However, before using the machine you
should check that the bevel gear is filled three-quarters
full with grease. Use HUSQVARNA special grease.
The grease in the bevel gear does not normally need to
be changed except if repairs are carried out.