Operators Manual
Table Of Contents
- Symbols
- Contents
- Note the following before starting:
- Dear Customer,
- Important
- Personal protective equipment
- Machine¢s safety equipment
- Fitting the handle
- Adjusting the harness
- Fitting the impact guard
- Fuel safety
- Fuel
- Fueling
- Check before starting
- Starting and stopping
- General working instructions
- Transport position
- Carburettor
- Muffler
- Cooling system
- Spark plug
- Air filter
- Gear
- Cleaning and lubrication
- Maintenance schedule
- Technical data
- EC Declaration of Conformity
ASSEMBLY
10 – English
Fitting the handle
Fit the handle using two screws.
Adjusting the harness
(325HE4)
You should always use the harness with the machine to
give maximum control over the machine and reduce the
risk of fatigue in your arms and back.
1 Put on the harness.
2 Hook the machine onto the harness support hook.
3 Adjust the length of the harness so that the support
hook is roughly level with your right hip.
Fitting the impact guard
(325HE4)
Fit the guard with three screws. Tighten the screws to 30
ft/lbs. (4 Nm). After the machine has been in use for
around 20 hours, re-tighten the screws to 4 Nm.