Owner manual

18 English
MAINTENANCE
Mufer
CAUTION! Some mufers are tted with a catalytic converter.
See chapter on Technical data to see whether your machine
is tted with a catalytic converter.
The mufer is designed to reduce the noise level and to direct
the exhaust gases away from the operator. The exhaust
gases are hot and can contain sparks, which may cause re
if directed against dry and combustible material.
Some mufers are equipped with a special spark arrestor
mesh. If your machine has this type of mufer, you should
clean the mesh at least once a week. This is best done with a
wire brush.
On mufers without a catalytic converter the mesh should be
cleaned weekly, or replaced if necessary. On mufers tted
with a catalytic converter the mesh should be checked, and if
necessary cleaned, monthly. If the mesh is damaged it
should be replaced.
If the mesh is frequently blocked, this can be a sign that the
performance of the catalytic converter is impaired. Contact
your dealer to inspect the mufer. A blocked mesh will cause
the machine to overheat and result in damage to the cylinder
and piston. See also instructions under the heading
Maintenance.
CAUTION! Never use a machine with a defective mufer.
Cooling system
To keep the working temperature as low as possible the
machine is equipped with a cooling system.
The cooling system consists of:
1 Air intake on the starter.
2 Fins on the ywheel.
3 Cooling ns on the cylinder.
4 Cylinder cover (directs cold air over the cylinder).
Clean the cooling system with a brush once a week, more
often in demanding conditions. A dirty or blocked cooling
system results in the machine overheating which causes
damage to the piston and cylinder.
Air lter
The air lter must be regularly cleaned to remove dust and dirt
in order to avoid:
Carburettor malfunctions
Starting problems
Loss of engine power
Unnecessary wear to engine parts
Excessive fuel consumption.
Clean the lter every 25 hours, or more regularly if conditions
are exceptionally dusty.
!
WARNING! Mufers tted with catalytic
converters get very hot during use and
remain so for some time after stopping. This
also applies at idle speed. Contact can result
in burns to the skin. Remember the risk of
re!