Operators Manual
Table Of Contents
- Symbols
- Contents
- Note the following before starting:
- Dear Customer,
- Important
- Personal protective equipment
- Machine¢s safety equipment
- Fitting the cutting head
- Fitting the bar and chain
- Fitting the impact guard (only some models)
- Telescopic function
- Adjusting the harness
- Fuel safety
- Fuel
- Fueling
- Check before starting
- Filling with oil
- Starting and stopping
- General working instructions
- Carburettor
- Muffler
- Cooling system
- Spark plug
- Air filter
- Gear
- Maintenance schedule
- Technical data
- EC Declaration of Conformity (Applies to Europe only)
English – 29
TECHNICAL DATA
Guide bar and saw chain combinations
EC Declaration of Conformity (Applies to Europe only)
Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel +46-36-146500, declares under sole responsibility that the pruning
saws
Husqvarna 327PT5S dating from 2014 serial numbers and onwards (the year is clearly stated on the rating plate,
followed by the serial number), comply with the requirements of the COUNCIL’S DIRECTIVE:
- of May 17, 2006 ”relating to machinery” 2006/42/EC.
- of December 15, 2004 ”relating to electromagnetic compatibility” 2004/108/EC.
The following standards have been applied:
EN ISO 12100:2010, CISPR 12:2005, EN ISO 11680-1:2011, EN ISO 14982:2009
SMP Svensk Maskinprovning AB, Box 7035, SE-750 07 Uppsala, Sweden, has performed voluntary type examination
on behalf of Husqvarna AB. The certificates are numbered:
0404, SMP Svensk Maskinprovning AB, Box 7035, SE-750 07 Uppsala, Sweden, has carried out EC type examination
in accordance with the machinery directive’s (2006/42/EC) article 12, point 3b. The certificate for EC type examination
in accordance with annex IV, has the number:
0404/11/2312
Huskvarna 19 may 2014
Per Gustafsson, Development manager (Authorized representative for Husqvarna AB and responsible for technical
documentation.)
The following combinations are CE approved.
Guide bar Saw chain
Length, inch Pitch, inch
10 1/4 Husqvarna H00
12 1/4 Husqvarna H00
D
2
L
_
D
PITCH =