Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Safety definitions
- General safety instructions
- Safety instructions for assembly
- Safety instructions for operation
- Personal protective equipment
- Safety devices on the product
- Fuel safety
- Safety instructions for maintenance
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Transportation and storage
- Technical data
- Accessories
- EC Declaration of Conformity
To cut the grass
1. Make sure that the trimmer line is parallel to the
ground when you cut the grass.
2. Do not push the trimmer head to the ground. This
can cause damage to the product.
3. Move the product from side to side when you cut
grass. Use full speed.
To sweep the grass
The airflow from the rotating trimmer line can be used to
remove cut grass from an area.
1. Hold the trimmer head and the trimmer line parallel
to the ground and above the ground.
2. Apply full throttle.
3. Move the trimmer head from side to side and sweep
the grass.
WARNING: Clean the trimmer head cover
each time you assemble new trimmer line to
prevent unbalance and vibrations in the
handles. Also do a check of the other parts
of the trimmer head and clean it if
necessary.
Maintenance
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
CAUTION: To prevent accidental start,
remove the spark plug cap from the spark
plug before you do maintenance on the
product.
Maintenance schedule
Maintenance Daily Weekly Monthly
Clean the external surface. X
Examine the harness for damages. X
Do a check for damages on the suspension ring. X
Do a check of the throttle trigger lockout and the throttle trigger. Refer to
To do a
check of the throttle trigger lockout on page 7
.
X
Make sure that the cutting attachment does not rotate at idle speed. X
Do a check of the stop switch. Refer to
To do a check of the stop switch on page
7
.
X
975 - 001 - 26.09.2019 19