User's Manual

16 – English

Repair instructions

Choke control – removal

Remove the cylinder cover, air filter and stop

switch. Disconnect the fuel hose from the carburet-

tor.

Stop switch – refitting

Carefully press the new stop switch into place.

Check that the switch’s upper mounting clips over

the air filter holder.

Refit the stop plate. Engage the stop plate in the

front slot first then lift the rear edge onto the stop

switch. Slide the stop plate in as far as it will go.

Refit:

• the leads to the stop plate and stop switch

• air filter

• cylinder

Disconnect the pushrod from the carburettor by first

carefully prising up the spring over the end of the

rod, where it connects to the throttle lever (A). Then

press the throttle lever forwards (B) while pressing

the throttle pushrod backwards (C) and lifting it off

the lever. Withdraw the throttle pushrod from the

tank and lift it upwards without pulling it through the

rubber inlet manifold. Carefully release the carbu-

rettor assembly from the right-hand rubber mount-

ing and lift it upwards.

NOTE!

Do not use knurled pliers to disconnect or

reconnect the fuel hose. This could

damage the hose and lead to leakage or

fracture.

Compress the clip that holds the choke control to

the carburettor while pulling it out at the same time.

Disconnect the choke control from the air filter

holder.