User's Manual

ManualsBrandsHusqvarna ManualsPetrol tool345

48 – English

4

Fit and tighten the six crankcase bolts to a torque

of 8–10 Nm. Check that the crankshaft rotates

freely.

5

Refit the following parts:

• bark rest

• oil pump*

• chain tensioner

• centrifugal clutch*

• fuel tank*

• piston and cylinder*

• generator*

• carburettor base

• carburettor*

• throttle pushrod

• silencer*

• ignition system*

• starter assembly*

• cylinder cover

• clutch cover

• guide bar and chain

* See special instructions.

NOTE!

If a new crankshaft has been fitted the

saw must be run in for 3-4 hours with the

carburettor adjusted to the factory set-

tings.

Crankshaft complete 340, 345, 350 –

reassembly

1

Fit the crankshaft complete in the crankcase.

350:

Fit and tighten the four bolts holding the spacer

from underneath and fit the crankshaft complete in

the crankcase.

Refit the following parts:

• piston and cylinder*

• fuel tank*

• silencer*

• carburettor*

• throttle pushrod

• centrifugal clutch*

• generator*

• ignition system*

• starter assembly*

• cylinder cover

• clutch cover

• chain and bar

* See special instructions.

Repair instructions