; A IEEE— Operator's manual | The engine exhaust from this product contains chemicals known 1o the State of California to cause 4 30BT cancer, birth defects or other reproductive harm. = 350BT/BF . er TOBIT S/BFS fore using pur products, please read this manual carefully to understand the proper use of your unit.
English FEDERAL EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY BRIGHTS AND OBLIGATIONS The EPA (The US Environmental Protection Agency, CRAB (California Air Resources Board), Environment Canada and Husbandman Forest 8 Garden are pleased to explain the emissions control stern warranty on your 2007 and tater small non road engine. In LS. and Canada, new small nonverbal engines must be designed, built and equipped to meet the federal stringent ant smog standards.
English Contents Warning labelsonthemachine FY Symbols Symbols on the machine. FE pees 5 Safety Precautions... cco virginal. eases WORKING CONDITIONS . WORKING CIRCUMSTANCE AVOID NOISE PROBLEM... WORKING PLAN... .. FUEL vein BEFORE STARTING THE ENGINE USING THE PRODUCT MAINTENANCE... ..
English Safety Notes on types of warnings SIS ie Instructions labeled as shown shove, concern critical steps or procedures which must be followed in order to prevent accidents which could idea to serious bodily Injury of death, This mark is used to indicate instructions which must be followed without exception. instructions labeled as shown above concern steps or procedures which, H not followed correctly, could lead to mechanical failure, breakdown, or damage.
English Symbols on the machine For safe operation and maintenance, symbols are carved in relief on the mariachi. Using to these indications, please be careful not to make a mistake.
English Ww i. To reduce the risk of injury . Ta reduce the risk of injury Safety Precautions IRKING CONDITIONS Behan from operating the blower if you are tired, Il, or upset, or i you are under the influence of alcohol, drugs or medication To reduce the risk of hearing loss associated with sound levels, hearing protection is required. associated with thrown objects, always wear eye protection and foot protection. Approved protective goggles must comply with standard ANSI Z87.
English Safety Precautions BEFORE STARTING THE ENGINE Each time before starting the orgies, inspect the entire anti fo sep If every part is in good order and is securely tightened in place. If any damage is found in the fuel line, the exhaust line, or the ignition wiring, do not use the blower until if has been repaired. Lien Before starting operation, always make sure to check if any obstacles are left inside the volute case and net. The obstacles may cause serious injury or damage to fan and volute case.
English Safety Precautions MAINTENANCE 1. In order to maintain your product in proper working order, perform the maintenance and checking operations described in the manual af regular intervals. . 2. Always ba sure to turn off the engine and disconnect the spark plug before performing any maintenance or checking procedures. The metallic parts, engine cover, and area around the engine reach high temperatures immediately after stopping the engine. 3.
English What is what? 1. Frame 18. Contra handle 2 Harness 17. Stop Butch with Thoth Position Se fling 8, Engine Cover 18. Throttle Lever 4. Volute Case, Cover 19. Handle Bar (Option) 5. Net 20. Elbow & Fan 21. Clamp {large} 7. Air Cleaner 22. Flexible Hose 5 Fe coll Starter 23. Clamp (slam) $. Fuel Tank 24. Swivel joint 10. Pad 25. Band 11. Spark Plug Cap 26. Pipes 12. Shock Barber (Spring) 27, Pipe end 13. Band (stopper) 28. Mat nozzle {option} 14. Shock Absorbent (Rubber) 25, Operator's manual 18.
English What is what? <35087T/BF> 1. Frame 16. 2. Sames 17 3. Engine Cover 18. 4. Polite Ass, Coder 19. 5 Net 20. 6. Fan 21. 7. Air Cleanser sz 8. Be coll Starter 23. 9. Fuel Tank 22, 10. Pad 25. 1, Spark Plug Gap 26 12. Shock Patisserie {Aruba) 27 13, Stock Arbitrator (Rubber) 28. 14. Choke Lever 29. 18. Control handle an.
English What is what? <370BTS/BFS> (4 5 RY «3TOBFS»> 1. Fame 16. Sta Switch with Throttle Position Effing 2. Harness 17 Throttles Aver a. Engine Cover 18. Handle Bar {Option} (3708TH any) 4. Volute Case, Cover 19. Elbow 5 Nat 20. Clam {large} 8 Fan 21. Flexible Hose 7. Air Gleaner 22. Clamp (small) 8. Recoil Starter 23. Swivel joint 8 Fuel Tank 24. Champ {for cabling) 10. Pag 25. Pipes 1%. Spark Plug Cap 26. Pips enc 12. Shock Absorbed (Rubber) 27. Flat nozzle {option} 13.
English What is what? <380BTS/BFS> «330BFS> 1 Frame 16. Stop Switch with Throttle Position Setting 2. Haas 17. Tootle Lever 3. Engine Cover 18. Handle Bar (Option) (3R08TS only) 4, Volts Case, Cover 19. Elbow § Net 20, Clamp (large) 8. Fan 21. Flexible Hose 7. Air Cleaner 22. Clamp (small) 8. Rico Starter 23. Swivel joint 9. Foul Tank 24. Clamp {for cabling} 10. Pad 25. Pipes 11. Spark Plug Cap 28. pipe end 12. Shock Absorbed (Rubber) 27. Flat nozzle {option) 13. Shock Absorbed {Rubber} 28.
Technical data English DELTA 13087 I508T 35081 370BTS A70BFE BORIS SKIBOBS Dimensions PILFERAGE (EXTRADITE) F50x446ra7e + 351xaBTed 1H {E8078 | OR EE20E Bacchanals | Hedonists {aia | (eons) 41005082447 410x550x497 {16.1x20x19.8) | {15 1x21.7X18.5) Dry Waiting kg [bs] (ou ing pips) 6.75 (14.9) 10.2228) 104228) 1265) | 122288) 13.2 (20.1) 18.4 (29.5) Bry Weight kg (64) without pr) 6.1 (13.4) 9.5 (20.9) 11.2 (24.7) 12.4 (27.3) Fuel Tank Capacity ior (1. oz) 0.9 (30.4) 1.25 (42.3) 2.48 (72.
English Assembly # FLEXIBLE HOSE AND SWIVEL JOINT 1. Connect the blower ard swivel joint with flexible hose, Clamp both ends of the flexible hose securely with the hardware supplied with the unit. {1} Flexible hose 2) Wive! joint {3} Clamp {large} 4) Clamp (small) A tight lubricant may be used to ease assembly of flexible hose to blower elbow. BE CONTROL HANDLE [1308 T/350BT/370BTS/330BTS] 1. Sell up the handle holder fo the wive! joint and tighten the knob on the older.
Assembly B BLOW PIPES Scent the swivel joint, straight pipe and pipe end. Push the pipes together and turn them so they lock in relation to one another unt the connection is locked. A light lubricant may be used to ease assembly of blower tube. Eel i longer tube is required, the second straight pipe can be connected with the first one.
English Fuel Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and aglow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 10ft (3m) away from the fueling point before starting the engine.
Operation E CONTROL ARM [350BF/370BFS/IBOBFS] ~ Hold the upper end of te control arm in hand and, while pulling it away from the unit, rotate arm forward {counterclockwise in the direction of the arrow) Lin til it clicks. (The first position) And if you want, you can rotate arm further until it clicks. (The second position) Choose the arm position according to your working condition. To fold the arm, reverse the order.
English Operation 8 ADJUSTING IDLE SPEED [13087] The ling speed Is set for 3000 rpm at the factory. If it is necessary to adjust the idle speed, use the adjustment screw on the {op side of carburetor, {gliding Adjustment Screw [350BT/BF] [370BTS/BFS] [380BTS/BFS] The idling speed is set for 2200 rpm [380BT/BF] or 2000 rpm [3POBTS/BFS] [BB0BTS/BFS] at the factory. If if is necessary to adjust the idle speed, use the adjustment screw on the top side of the carburetor.
Maintenance English Maintenance, replacement, or repair of the emission control device and systems may be performed by any nor-road engine repair establishment or individual, Contemporaneous Procedure Daily or Every 25 Every 58 Every 100 Before use | hours after | hours after | hours after Air Profiteer Inspect/Clean x Filter "Paper Filter (370 only) | Inspect Replace x Fuel Leaks inspectorate x Fuel Filter inspect/Replace X x Fuel Ling inspect/Clean x Spark Plug Inspection X Muffler Inspect/Clean Bolts on
English Maintenance [370BTS/BFS] [380BTS/BFS) (F31) 1. Unscrew 2 knob bolts and remove the air cleaner cover, Then remove the profiteer mounted inside the air cleaner cover, niobium Bolt 2) Filterer Sinner Case [380BTS/BFS) 4) Paper Filter 2. Wash the filterer in fresh, nen flammable dealing solution {ex. warm soapy water) and then dry. (Clean the air tier once in a week.) 3. Exchange the paper filter element with new one in case it has been contaminated. i rain «This preterit Is dry type.
Maintenance B COOLING SYSTEM To keep the working temperature as low as possible the machine is equipped with a cooling system. £1} Cooling fins on the cylinder. Clear: the coiling stern with a brush once a week, more often in demanding conditions. A dirty or blocked cooling system results in the machine overheating which causes damage to the piston and cylinder. B AIR INLET NET LUE ~ Blown alr Is taken in from the air inlet net.