Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Operation
- Maintenance
- Introduction
- Maintenance schedule
- Maintenance and checks of the safety devices on the product
- To do a check of the brake band
- To do a check of the front hand guard and the chain brake activation
- To do a check of the chain brake
- To do a check of the throttle trigger and throttle trigger lockout
- To do a check of the chain catcher
- To do a check of the right hand guard
- To do a check of the vibration damping system
- To do a check of the start/stop switch
- To do a check of the muffler
- Carburetor with adjustment limitations
- Carburetor without adjustment limitations
- To examine if the carburetor is correctly adjusted
- To replace a broken or worn starter rope
- To tighten the recoil spring
- To assemble the starter housing on the product
- To clean the air filter
- To do a check of the spark plug
- To calculate the felling direction
- To sharpen the saw chain
- To adjust the tension of the saw chain
- To do a check of the saw chain lubrication
- To do a check of the rim sprocket
- To lubricate the needle bearing
- To examine the cutting equipment
- To do a check of the guide bar
- To do maintenance on the fuel tank and the chain oil tank
- To adjust the chain oil flow
- Air cleaning system
- To clean the cooling system
- Troubleshooting
- Transportation and storage
- Technical data
- Accessories
- EC Declaration of Conformity
Contents
Introduction..................................................................... 2
Safety..............................................................................
3
Assembly........................................................................ 9
Operation........................................................................ 9
Maintenance................................................................. 20
Troubleshooting............................................................ 33
Transportation and storage...........................................34
Technical data.............................................................. 34
Accessories.................................................................. 36
EC Declaration of Conformity....................................... 38
Introduction
Intended use
This product is intended for sawing in wood.
Note: National regulations can set limit to the operation
of the product.
Product description
The Husqvarna
362, 372 XP, 372 XPG are chainsaw
models with a combustion engine.
Work is constantly in progress to increase your safety
and efficiency during operation. Speak to your servicing
dealer for more information.
Product overview
8
33
34
21
27
16
30
17
12
9
20103011
4
2
22
3
5
6
28
19
31
32
7
30
18
24
25
23
26
1
29
13 14 15
1. Air filter cover 2. Front handle
2 593 - 001 - 20.01.2020