® Glide Master 340 Glide Master 360 Glide Master 380 Original Instructions AT ORM ION F T IN N A RT e e I M P O before us referenc re Read in for futu a & ret
Carton Contents Easi Reel cable winder electric cable with moulded plug start/stop levers switchbox cutting height spacers (1 fitted to lawnmower & 2 inside product under grassbox) instruction manual spanner/scraper tool (inside product under grassbox) IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna UK Ltd.
Electrical 1. The British Standards Institute recommend the use of a Residual Current Device (R.C.D.) with a tripping current of not more than 30mA. Even with a R.C.D. installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Check your R.C.D. every time you use it. 2. Before use, examine the cable for signs of damage or ageing, If the cable is found to be defective, take the product to an Authorised Service Centre and have the cable replaced. 3.
Assembly Instructions A B Preparing your lawnmower for use • Your lawnmower is supplied with the upper handle folded over the machine for packing and transportation. Handle in Operating Position 1. Lift handle as illustrated in figure A. • Do not drop the handle. • Make sure that the cable does not become trapped between the handles Attach the Easi-Reel cable winder as illustrated in figure B This is used to store the power cable after using the product - see ‘Easi-Reel Cable Winder’ section.
Grassbox Instructions J grassbox is full grassbox is empty K Grassbox Full (J) 1. As the grassbox fills up, grass will be clearly visible through the window in the lid (J). 2. When the window is full it is time to empty the grassbox. Emptying the Grass • Stop the lawnmower, and wait until the blade has stopped rotating BEFORE lifting the grassbox lid. 1. Lift grassbox lid. (K) 2. Lift out grassbox and empty. (L) 3. Replace grassbox and close lid carefully.
Spanner & Spacers N There is a spanner and additional spacers, for height adjustment, stored inside the lawnmower underneath the grassbox.(N) These can be stored inside the lawnmower even whilst it is use. Adjusting the Cutting Height Always handle the blade with care - sharp edges could cause injury. USE GLOVES. Never use more than 3 Cutting Height Spacers. Spacers must only be fitted between the blade and the fan and NEVER between the blade and the bolt. 1.
Caring for your Lawnmower Cleaning IMPORTANT: It is very important that you keep your lawnmower clean. Grass clippings left in any of the air intakes or under the hood could become a potential fire hazard. USE GLOVES. Switch off and remove the plug from the mains before cleaning. It is recommended that you clean your lawnmower straight after mowing while the grass is still wet. 1. Remove grass from under the hood with the spanner/scraper tool provided. (R1) 2.
Fault Finding Hints Fails to Operate 1. Is the correct Starting procedure being followed? See ‘To Start your Lawnmower’ 2. Is the Power Turned On? 3. Check the fuse in the plug, if blown replace. 4. Fuse continues to blow? Immediately disconnect from the mains electricity supply and consult your local approved Service Centre. Poor Flotation 1. Disconnect from the mains electricity supply. 2. Clean the underside of the hood and the fan blades. 3. Raise to a higher height of cut.
Environmental Information Husqvarna UK Ltd. are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the products’ life. • Packaging is recyclable and plastic components have been labelled (where practical) for categorised recycling.
