Operating Guide

ACLARACION DE LOS SIMBOLOS
72 – Spanish
1154886-49 Rev.6 2014-12-03
EPA III
El período de cumplimiento de emisiones mencionado en
la etiqueta de cumplimiento de emisiones indica el
número de horas de funcionamiento en el que el motor ha
demostrado cumplir con los requisitos federales en
materia de emisiones.
El mantenimiento, sustitución o reparación de aparatos y
sistemas de control de las emisiones puede efectuarlos
cualquier establecimiento o individuo dedicado a la
reperación de motores no de carretera.
Para atención al cliente, llama al:
1-800-487-5951
Visítanos en nuestra pagina de red:
www.husqvarna.com
English – 33
TECHNICAL DATA
1154886-49 Rev.6 2014-12-03
Recommended cutting equipment for USA
Following is a list of recommended cutting equipment for Husqvarna chain saw model 440. This chain saw model
equipped with either of the listed bar and saw chain combination(s), fulfills the requirements according to ANSI B175.1-
2000 (Gasoline Powered Chain Saws - Safety Requirements).
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
Chain saw model Husqvarna 440 met the kickback performance requirements of ANSI B175.1-2000 when tested with
the combinations of bars and saw chains listed below. The saw chain Husqvarna H30 is also classified as a low kickback
saw chain since it met the requirements for low kickback saw chain outlined in ANSI B175.1-2000. We recommend to
use only the listed combinations of bars and chains for chain saw model Husqvarna 440. Other chain saw models may
not meet the kickback requirements when equipped with the listed guide bar and saw chain combinations.
Recommended cutting equipment for Canada
Following is a list of recommended cutting equipment for the Husqvarna chainsaw model 440. The listed combination(s)
of powerhead, bar and saw chain meet all requirements outlined in Canadian Standards Assosiation Z62.1-03 (Chain
Saws) and Z62.3-04 (Chain Saw Kickback).
Furthermore the saw chain Husqvarna H30 is evaluated and listed as a Type C Low Kickback Saw Chain according to
the provisions in Z62.3-04.
Kickback information
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
Guide bar and saw chain combinations
Saw chain filing and file gauges
Guide bar Saw chain
Length, inch Pitch, inch
Thickness of drive
links, inch/mm
Max. nose radius Type Drive link count
16
0.325 0.050 10T Husqvarna H30
66
18 72