Operating Guide

FEDERAL AND CALIFORNIA EMISSIONS CONTROL WARRANTY STATEMENT
34 – English
1154886-49 Rev.6 2014-12-03
IMPORTANT: This product is compliant with U.S. EPA
Phase 3 regulations for exhaust and evaporative
emissions. To ensure EPA Phase 3 compliance, we
recommend using only genuine Husqvarna brand
replacement parts. Use of non-compliant replacement
parts is a violation of federal law.
YOUR WARRANTY RIGHTS AND
OBLIGATIONS
The EPA (U.S. Environmental Protection Agency), CARB
(California Air Resources Board), Environment Canada
and Husqvarna Forest & Garden are pleased to explain
the emissions control system’s warranty on your 2015-
2016* small off-road engine. In U.S. and Canada, small
off-road engines must be designed, built, and equipped to
meet the applicable Federal or California stringent anti-
smog standards. Husqvarna Forest & Garden must
warrant the emissions control system on your small off-
road engine for the period of time listed below provided
there has been no abuse, neglect or improper
maintenance of your small off-road engine. Your emission
control system may include parts such as the carburetor,
fuel-injection system, the ignition system, catalytic
convertor, fuel tanks, fuel lines, fuel caps, valves,
canisters, filters, vapor hoses, clamps, connectors, and
other associated emission-related components. For
engines less than or equal to 80 cc, only the fuel tank is
subject to the evaporative emission control warranty
requirements of this section (California only). Where a
warrantable condition exists, Husqvarna Forest & Garden
will repair your small off-road engine at no cost to you
including diagnosis, parts and labor.
MANUFACTURER′′
′′
S WARRANTY
COVERAGE
The emissions control system is warranted for two years.
If any emissions-related part on your small off-road
engine is defective, the part will be repaired or replaced by
Husqvarna Forest & Garden.
OWNER′′
′′
S WARRANTY
RESPONSIBILITIES
• As the small off-road engine owner, you are
responsible for performance of the required
maintenance listed in your operator’s manual.
Husqvarna Forest & Garden recommends that you
retain all receipts covering maintenance on your small
off-road engine, but Husqvarna Forest & Garden
cannot deny warranty solely for the lack of receipts or
your failure to ensure the performance of all
scheduled maintenance.
• As the small off-road engine owner, you should
however be aware that Husqvarna Forest & Garden
may deny you warranty coverage if your small off-road
engine or a part has failed due to abuse, neglect, or
improper maintenance or unapproved modifications.
• You are responsible for presenting your small off-road
engine to a Husqvarna Forest & Garden distribution
center or service center as soon as the problem
exists. The warranty repairs should be completed in a
reasonable amount of time, not to exceed 30 days. If
you have any questions regarding your warranty
coverage, you should contact Husqvarna Forest &
Garden in USA at 1-800-487-5951, in CANADA at
1-800-805-5523 or send e-mail correspondence to
[e-mail].
WARRANTY COMMENCEMENT DATE
The warranty period begins on the date the engine or
equipment is delivered to an ultimate purchaser.
LENGTH OF COVERAGE
Husqvarna Forest & Garden warrants to the ultimate
purchaser and each subsequent owner that the engine or
equipment is designed, built, and equipped so as to
conform with all applicable regulations adopted by EPA
and CARB, and is free from defects in materials and
workmanship that causes the failure of a warranted part
for a period of two years.
WHAT IS COVERED
REPAIR OR REPLACEMENT OF PARTS Repair or
replacement of any warranted part under the warranty
must be performed at no charge to the owner at a
warranty station. Warranty services or repairs will be
provided at all Husqvarna Forest & Garden distribution
centers that are franchised to service the subject engines.
Throughout the emissions warranty period of two years,
Husqvarna Forest & Garden must maintain a supply of
warranted parts sufficient to meet the expected demand
for such parts.
WARRANTY PERIOD Any warranted part that is
scheduled for replacement as required in the
maintenance schedule, is warranted for the period of time
prior to the first scheduled replacement point for that part.
If the part fails prior to the first scheduled replacement, the
part will be repaired or replaced by Husqvarna Forest &
Garden at no cost. Any such part repaired or replaced
under warranty is warranted for the remainder of the
period prior to the first scheduled replacement point for
the part. Any warranted part that is not scheduled for
replacement as required in the maintenance schedule, is
warranted for two years. If any such part fails during the
period of warranty coverage, it will be repaired and
replaced by Husqvarna Forest & Garden at no cost. Any
such part repaired or replaced under the warranty is
warranted for the remaining warranty period. Any
warranted part that is scheduled only for regular
inspection in the maintenance schedule will be warranted
for a period of two years. A statement in such written
instructions to the effect of ”repair or replace as
necessary” will not reduce the period of warranty
coverage. Any such part repaired or replaced under
warranty will be warranted for the remaining warranty
period.
DIAGNOSIS The owner must not be charged for
diagnostic labor that leads to the determination that a
warranted part is in fact defective, provided that such
diagnostic work is performed at a warranty station.
CONSEQUENTIAL DAMAGES Husqvarna Forest &
Garden is liable for damages to other engine components
proximately caused by a failure under warranty of any
warranted part.
ACLARACION DE LOS SIMBOLOS
Spanish – 71
1154886-49 Rev.6 2014-12-03
Símbolos en la máquina en/o el
manual de instrucciones:
¡ATENCION! ¡Las motosierras pueden
ser peligrosas! Su uso descuidado o
erróneo puede provocar heridas graves o
mortales al operador o terceros.
Lea detenidamente el manual de
instrucciones y asegúrese de entender
su contenido antes de utilizar la
máquina.
Utilice siempre:
• Casco protector homologado
• Protectores auriculares
homologados
• Gafas protectoras o visor
El operador debe manejar la motosierra
con ambas manos.
No manejar nunca una motosierra
sujetándola sólo con una mano.
Debe evitarse que la punta de la espada
entre en contacto con ningún objeto.
¡ATENCION! Si la punta de la espada
toca en un objeto se puede producir
reculada que lanza la espada hacia
arriba y atrás contra el usuario. Ello
puede causar daños personales graves.
Freno de cadena, activado
(derecha). Freno de cadena, no
activado (izquierda).
Válvula de descompresión: Prima
la válvula para reducir la presión en el
cilindro y facilitar el arranque de la
máquina. La válvula de descompresión
debe utilizarse siempre para los
aranques.
Encendido; estrangulador: Ponga el
estrangulador en la posición de
estrangulamiento. Entonces, el botón de
parada se desplazará automáticamente
hacia la posición de arranque.
Ajuste de la bomba de aceite.
Los demás símbolos/etiquetas que
aparecen en la máquina corresponden a requisitos de
homologación específicos en determinados
mercados.
Los trabajos de control y/o
mantenimiento deben efectuarse
con el motor desconectado. ¡NOTA!
El contacto de arranque/parada
retorna automáticamente a la
posición de marcha. Por
consiguiente, para evitar el arranque
involuntario hay que quitar siempre
el capuchón de encendido de la
bujía antes de realizar trabajos de
montaje, control y/o mantenimiento.
Utilice siempre guantes protectores
homologados.
La máquina debe limpiarse
regularmente.
Control visual.
Debe utilizarse gafas protectoras o
visor.
Carga de combustible.
Carga de aceite y regulación del
caudal de aceite.
El freno de cadena debe estar
activado al poner en marcha la
motosierra.
Etiquetas que se encuentran en la motosierra: