Operators Manual

A
C
B
3.12.4.1 GPS Assisted Navigation
Only for Automower
®
430X/450X.
The GPS Assisted Navigation function helps the
product to select the most optimal operation. Use
the Lawn coverage function to do manual
settings.
To set the GPS Assisted Navigation
Disable the GPS Assisted Navigation to make
manual settings in
Lawn coverage .
Note: It is recommended to use GPS Assisted
Navigation.
1. Do steps 1–3 in To get access to the menu
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Installation
> Lawn coverage
.
3. Push the OK button to enble or disable the
function.
4. Push the BACK button.
3.12.4.2 To set the Lawn Coverage function
1. Do steps 1–3 in
To get access to the menu
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Installation
> Lawn Coverage > Area 1-3
.
3. Use the arrow button to select the area.
4. Push the OK button.
5. Measure the distance from the charging
station to the start of the area. Measure
along the guide wire. Refer to
To measure
the distance from the charging station on
page 30
.
6. Push the number buttons to select the
distance.
7. Push the OK button.
8. Use the number buttons to select the
percentage of the cutting time the product
must cut the area. The percentage is equal
to the area in relation to the complete work
area.
a) Measure the area.
b) Divide the measured area with the total
work area.
c) Convert the result to percentage.
Note: The sum of Area 1-3 must be 100% or
less. If the sum is less than 100%, the
product sometimes starts to mow at the
charging station. Refer to
To set the exit
angle on page 32 .
9. Push the BACK button.
3.12.4.3 To do a test of the Lawn Coverage
function
1. Put the product in the charging station.
2. Do step 1-3 in
To get access to the menu on
page 26
.
3. Use the arrow buttons and the OK button to
move through the menu structure Installation
> Lawn Coverage > Area 1-3 > More > Test
.
4. Push the OK button.
5. Push the START button.
6. Close the hatch.
7. Make sure the product can find the area.
3.12.4.4 To measure the distance from the
charging station
1. Put the product in the charging station.
2. Do steps 1–3 in
To get access to the menu
on page 26
.
3. Use the arrow buttons and the OK button to
move through the menu structure
Installation
> Lawn Coverage > Area 1-3 > How far?
4. Use the number buttons to set 500 m / 500
yd as a distance.
5. Push the OK button.
30
- Installation
1201 - 003 - 25.03.2020