Operators Manual

6 Troubleshooting
6.1 Introduction - troubleshooting
In this chapter, faults and symptoms are described and can guide you if the product does not operate
as expected. More suggestions for steps to take in the event of malfunction or symptoms can be found
on www.husqvarna.com.
6.2 Fault messages
The list below shows a number of fault messages that may be shown in the display of the product.
Speak to your local Husqvarna representative if the same message shows frequently.
Message Cause Action
Wheel motor
blocked
Grass or other objects is wound around
the drive wheel.
Examine the drive wheel and remove
the grass or other object.
Cutting system
blocked
Grass or other objects is wound around
the blade disc.
Examine the drive wheel and remove
the grass or other object.
The blade disc are in a pool of water. Move the product and prevent the col-
lection of water in the work area.
Cutting height
blocked
Grass or other objects is wound around
the cutting height adjustment, or be-
tween the blade disc and chassis.
Examine the blade disc and the bellows
around the cutting height adjustment,
and remove any grass or other objects
that may have got stuck.
Trapped The product is blocked in a small area
behind a number of obstacles.
Examine if there are obstacles which
make it hard for the product to move
away from this location.
1201 - 003 - 25.03.2020
Troubleshooting - 45