Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Installation
- Introduction - Installation
- Main components for installation
- General preparations
- Before the installation of the wires
- Installation of the product
- To put the wire into position with stakes
- To bury the boundary wire or the guide wire
- To extend the boundary wire or the guide wire
- After the installation of the product
- Automower® Connect app
- To do the product settings
- To get access to the menu
- Menu structure
- Schedule
- Weather timer
- Lawn Coverage
- Methods for the product to find the charging station
- Corridor width
- Exit angle
- Reversing distance
- Drive Past Wire function
- Settings
- ECO mode
- General
- Accessories
- Operation
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Warranty
- EC Declaration of Conformity
Message Cause Action
Battery tempera-
ture outside limits
The product does not operate if the bat-
tery temperature is too high or too low.
The product starts to operate again
when the temperature is between the
set limits and the schedule settings let
the product to operate. Make sure that
the charging station is put in an area
with protection from the sun.
Charging current
too high
Wrong or faulty power supply unit. Restart the product.
If the problem stays, speak to your ap-
proved servicing dealer.
Connectivity prob-
lem
Potential problem on the connectivity
circuit board in the product.
Restart the product.
If the problem stays, speak to your ap-
proved servicing dealer.
50 - Troubleshooting
1201 - 003 - 25.03.2020