Operators Manual

6.3 Information messages
The list below shows a number of information messages that may be found in the Messages menu in
the Automower
®
Connect app. Contact your local Husqvarna representative if the same message
appears often.
Message
Cause Action
Low battery The product cannot find the charging
station.
Change the position of the guide wire.
Refer to To install the guide wire on
page 23 .
Make sure that the installation settings
about how to find the charging station
is correct. Refer to Methods for the
product to find the charging station on
page 31 .
The battery is spent. Replace the battery. Refer to Battery
on page 43 .
The charging station’s antenna is de-
fective.
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 54 . This problem requires ac-
tion by authorized service technician.
Settings restored Confirmation that a Reset all user set-
tings has been carried out.
This is normal. No action required.
Limited cutting
height
The cutting height adjustment cannot
move.
Examine the cutting height adjustment
and remove grass or other objects. If
the problem stays, speak to your ap-
proved servicing dealer.
Unexpected cut-
ting height adj
Limited cutting
height range
Cutting height
problem
Cutting height
blocked
Cutting system im-
balance
The product has discovered vibrations
in the cutting disc.
Verify that the blades and screws are
intact and not worn out. Verify that all
blades are correctly mounted. Check
that no double blades are mounted on
any of the three blade positions.
Slope too steep The product stopped because the slope
is too steep.
Change the installation of the boundary
wire to not include this steep part of the
work area. Refer to To put the boun-
dary wire in a slope on page 19 .
1201 - 003 - 25.03.2020
Troubleshooting - 51