Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Installation
- Introduction - Installation
- Main components for installation
- General preparations
- Before the installation of the wires
- Installation of the product
- To put the wire into position with stakes
- To bury the boundary wire or the guide wire
- To extend the boundary wire or the guide wire
- After the installation of the product
- Automower® Connect app
- To do the product settings
- To get access to the menu
- Menu structure
- Schedule
- Weather timer
- Lawn Coverage
- Methods for the product to find the charging station
- Corridor width
- Exit angle
- Reversing distance
- Drive Past Wire function
- Settings
- ECO mode
- General
- Accessories
- Operation
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Warranty
- EC Declaration of Conformity
6.5 Symptoms
If your product does not work as expected, follow the symptoms guide below.
There is a FAQ (Frequently Asked Questions) on www.husqvarna.com which provides more detailed
answers to a number of standard questions. Contact Husqvarna customer service if you still cannot find
the reason for the fault.
Symptoms Cause Action
The product has
difficulty docking.
The guide wire is not laid in a long
straight line that is far enough out from
the charging station.
Check that the charging station has
been installed according to the instruc-
tions in
To examine where to put the
boundary wire on page 17
The guide wire is not inserted in the
slot under the charging station.
Make sure that the guide wire is in the
correct position below the charging sta-
tion. Refer to
To install the guide wire
on page 23
.
The charging station is not on a level
surface.
Place the charging station on a surface
that is entirely level. Refer to
To exam-
ine where to put the charging station on
page 16
.
The product runs
at the wrong time
The clock or the date in the product is
not correct.
Set the clock or date. Refer to
To set
the time & date on page 34
.
The start and stop times for mowing
are incorrect.
Change the
Schedule
settings. Refer to
Schedule on page 26
.
The product vi-
brates.
Damaged blades lead to imbalance in
the cutting system.
Inspect the blades and screws and re-
place them if necessary. Refer to
Re-
place the blades on page 43
.
Too many blades in the same position
lead to imbalance in the cutting system.
Check that only one blade is fitted at
each screw.
Different versions (thickness) of blades
are used.
Check if the blades are of different ver-
sions.
The product runs,
but the blade disc
does not rotate.
The product searches for the charging
station, or is reversing out of the charg-
ing station.
No action. The blade disc does not ro-
tate when the product is searching for
the charging station.
The product mows
for shorter periods
than usual be-
tween charges.
Grass or other foreign object blocks the
blade disc.
Remove and clean the blade disc. Re-
fer to
Chassis and blade disc on page
42
.
The battery is spent. Replace the battery. Refer to
Battery
on page 43
.
Dull blades. More energy is needed
when cutting the grass.
Replace the blades. Refer to
Replace
the blades on page 43
.
1201 - 003 - 25.03.2020 Troubleshooting - 55