Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Installation
- Introduction - Installation
- Main components for installation
- General preparations
- Before the installation of the wires
- Installation of the product
- To put the wire into position with stakes
- To bury the boundary wire or the guide wire
- To extend the boundary wire or the guide wire
- After the installation of the product
- Automower® Connect app
- To do the product settings
- To get access to the menu
- Menu structure
- Schedule
- Weather timer
- Lawn Coverage
- Methods for the product to find the charging station
- Corridor width
- Exit angle
- Reversing distance
- Drive Past Wire function
- Settings
- ECO mode
- General
- Accessories
- Operation
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Warranty
- EC Declaration of Conformity
7 Transportation, storage and disposal
7.1 Transportation
The supplied Li-ion batteries obey the Dangerous
Goods Legislation requirements.
• Obey all applicable national regulations.
• Obey the special requirement on package
and labels for commercial transportations,
including by third parties and forwarding
agents.
7.2 Storage
• Fully charge the product. Refer to
To charge
the battery on page 40
.
• Switch off the product. Refer to
To switch off
the product on page 40
.
• Clean the product. Refer to
Clean the
product on page 42
.
• Keep the product in a dry, frost free space.
• Keep the product with all wheels on level
ground during storage, or use a wall hanger.
• If you keep the charging station indoors,
disconnect and remove the power supply
and all the connectors from the charging
station. Put the end of each connector wire
in a connector protection box.
Note: If you keep the charging station
outdoors, do not disconnect the power
supply and the connectors.
• Contact Husqvarna sales representative
about what accessories are available for
your product.
7.3 Disposal
• Obey the local recycling requirements and
applicable regulations.
• For questions about how to remove the
battery, refer to
To remove the battery on
page 59
.
7.3.1 To remove the battery
CAUTION:
Only remove the battery
when you dispose the product. When
you remove the warranty seal, the
Husqvarna warranty is no longer
applicable.
1. Switch off the product. Refer to
To switch off
the product on page 40
.
2. Pull out the grommet on the charging cable
at the very front of the product, and carefully
remove the connector.
3. Lift the cover, one corner at a time.
4. Remove the 14 screws with a Torx 20.
5. Lift the rear edge of the top section of the
chassis.
6. Disconnect the cable from the main circuit
board.
7. Remove the top section of the chassis.
8. Remove the 4 screws that hold the battery
with a Torx 20.
9. Disconnect the battery connection from the
main circuit board.
10. Open the battery cover and remove the
battery.
1201 - 003 - 25.03.2020
Transportation, storage and
disposal - 59