Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Operation
- Maintenance
- Introduction
- Maintenance schedule
- To adjust the idle speed
- To do maintenance on the muffler
- Cooling system
- To examine the spark plug
- Air filter
- To check the chain drive sprocket
- To examine the cutting equipment
- To do a check of the guide bar
- To sharpen the saw chain
- Information about the guide bar and saw chain
- General information about how to sharpen the cutters
- To sharpen the cutters
- General information about how to adjust the depth gauge setting
- To adjust the depth gauge setting
- To tension the chain
- To fill with chain oil
- To check the chain lubrication
- To adjust chain lubrication
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Accessories
- EC Declaration of Conformity
525PT5S
Equipped with approved accessory (original) 89
Vibration levels
3
Vibration levels at handles, measured according to ISO 22867, m/s
2
:
Short shaft, front/rear handles 6.3/5.3
Extended shaft, front/rear handles 4.1/6.7
Accessories
Guidebar and saw chain combinations
Recommended guide bar and saw chain combination.
Note: This guide bar deviates from the Husqvarna
standard and must be of type A318 to fit the product.
Guide bar Saw chain
Length, in/cm Pitch, in Gauge, in/mm Type
Length, drive links,
no.
10/25 1/4 0.050/1.3
Husqvarna H00
58
12/31 64
Filing equipment and filing angles
Using Husqvarna file gauge will give you the correct
filing angles. We recommend you to always use a
Husqvarna file gauge to restore the sharpness of the
saw chain. The part numbers are given in the table
below.
If you do not know which saw chain you have on your
product, turn to your servicing dealer.
H00 5/32 in / 4.0 mm 85° 30°
0.025 in /
0.65 mm
580 68 74-01
3
Reported data for equivalent vibration level has a typical statistical dispersion (standard deviation) of 1 m/s
2
.
24 712 - 003 - 18.02.2019