Operators Manual

20 - English

Safety equipment

6.5 Resistance test - stop switch

Dismantle the stop switch as outlined.

Clean the contact areas.

test the resistance by connecting a multimeter to

the stop switch. The resistance should be as fol-

low:

”0” pressed in - less than 0.1 Ω.

”1” pressed in - more than 1000 Ω.

6.6 Dismantling Throttle

Assembly of the throttle is done in the reverse order

as set out for dismantling.

Position the parts in the left-hand throttle half.

Dismantle the clutch housing cover from engine

body, see Dismantling the shaft from engine

body.

Remove screw that holding the shaft, (A).

Loosen the screws (B) holding the clamp around

the shaft.

Remove the shaft assembly from engine body and

the throttle from the shaft.

Remove the screw (C) holding the shaft.

Remove the 5 screws (D, E) holding the handle in

place.

Carefully remove the right handle half and make

sure that the anti vibration element (F) is not lost

(one on each side of the clamping sleeve).

Note how the different parts are fitted.

Remove the clamping sleeve (G).

Note how the throttle’s recoil spring (H) is fitted and

remove the throttle lever.

Remove the throttle trigger lock (J) and the anti

vibration element (K).