Operators Manual

38 - English

Repair instructions

7.15 Assembling the carburettor

• Blowallchannelsinthecarburettorcompart-

ment clean

• Mountanewplug(A).

Use a suitable punch to get a completely tight

seal.

• Pressinanewmainjet(B).

• Mountthevalvesandsprings.

Tip!

Any numbers on the valves should be able to be

read from the outside.

Make sure valves has a perfekt seal by locking at

the edge of the valve with tha carburettor backlit, a

light from the choke side.

Also make sure there are no clearence between

axial stop (e-clip in this case) and the carburettor

housing.

Replace the fuel screen if it is damaged or cannot

be cleaned.

Place the pump diaphragm closest to the

carburettor housing. Then the gasket and cover

and the other components in reverse order of

removal.