Operators Manual

English - 43
Repair instructions
Using the puller, 510 13 89-01, remove the rotor
from the crankshaft. The removal bolts on the puller
differ according to the engine.
Removal bolt size M6 (WAF 10 mm)
NOTE!
Screw the removal bolt into the rotor until
the thread is at least halfway in.
Fig 4
A Removal bolt
B Puller bolt
C Rotor
D Puller
A
D
B
A
Take out the flywheel nut (A).
Rotor nut width across flats (WAF) M8 (WAF 12
mm)
NOTE!
Slowly turn the rotor counterclockwise,
and after applying the stopper (special
tool) lightly to the piston head, loosen
the nut. The piston head could be dama-
ged if force is applied too sharply when
loosening the nut.
C