Operators Manual

English - 63

Repair instructions

7.28 Assembling the bevel gear

Clean all component parts and replace if damaged

or worn.

Fit the bearings on respective axles. This is easier

if the bearings are heated to approx. 110°C using a

hot air gun.

The bearings on the input axle are sealed on one

side. Turn the bearings so this side faces outwards.

NOTE!

Do not forget the circlip (A) holding the

bearing on the input axle.

Heat the gearbox to approx. 110°C and first place

the output axle in position and then the input axle.

Make sure the bearing bottoms in its seating.

Fit the circlips (B) and (C). Make sure they lie

correctly in their grooves.

Assemble remaining parts in the reverse order as

set out for dismantling

NOTE!

Do not forget to fill the gear housing to

approx. 3/4 with gear housing grease 503 97

64-01 once the plug (D) has been removed.