Operators Manual

2. Slide the battery into the battery holder of the
product. The battery must slide easily, if not, it is not
installed correctly.
3. Press the lower part of the battery and push it in as
far as it will go into the battery compartment. The
battery will lock into position when you hear a click.
4. Make sure that the latches snap in place correctly.
To connect the backpack battery to the
product
1. Connect the adapter cable from the product to the
backpack battery.
2. Fasten the battery cable in the attachments on the
harness.
3. When the back pack battery is used, carry the
backpack battery on the back.
To start the product
1. Press and hold the start button until the green LED
light comes on.
2. Use the power trigger to control the speed.
To start the product
When the backpack battery starts there is a startup time
of about 4 seconds (software booting). During that time,
you can hear the fans inside the backpack battery
blowing and a green LED on the battery blinks. When
the green LED is lit on the battery, the product is ready
to start.
1. Start the backpack battery. Do not proceed the steps
that follow before the green LED is lit.
2. Press and hold the start button until the green LED
light comes on.
3. Use the power trigger to control the speed.
To stop the product
1. Release the power trigger.
2. Press and hold the stop button until the green LED
light comes off.
3. Remove the battery from the product. Press the two
release buttons and pull out the battery.
To stop product and the backpack
battery
1. Release the power trigger.
2. Press and hold the stop button until the green LED
light comes off.
10
519 - 002 - 30.05.2018