Operators Manual
Table Of Contents
- Introduction
- Safety
- Assembly
- Operation
- Introduction
- To do a function check before you use the product
- To connect the battery charger
- Backpack battery (530iBX)
- To charge the battery
- To connect the battery to the product
- To connect the backpack battery to the product
- To start the product
- To start the product
- To stop the product
- To stop product and the backpack battery
- To set the optimal airflow for your work
- To temporarily increase the airflow
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Accessories
- EC Declaration of Conformity
Maintenance Daily Weekly Monthly
Make sure that the start/stop button works correctly and is not damaged. X
Make sure the power trigger is functioning properly with regard to safety. X
Check that nuts and screws are tight. X
Check that the battery is intact. X
Check the battery's charge. X
Check that the release buttons on the battery works and locks the battery into
the machine.
X
Check that the battery charger is intact and functional. X
Check that all couplings, connections and cables are intact and free from dirt. X
Check the connections between the battery and the machine and also check the
connection between battery and the battery charger.
X
To do a check of the air intake
1. Make sure that the air intake is not blocked on any
side on the product.
2. Stop the product and remove leaves or unwanted
material if necessary.
CAUTION: A blocked air intake
decreases the blowing capacity of the
product and increases the motor's
working temperature. This can result in
motor failure due to overheating.
To examine the battery and the battery
charger
1. Examine the battery for damages, for example
cracks.
2. Examine the battery charger for damages, for
example cracks.
3. Make sure that the battery charger connection wire
is intact and that there are no cracks in it.
To clean the product, the battery and
the battery charger
1. Clean the product with a dry cloth after use.
2. Clean the battery and battery charger with a dry
cloth. Keep the battery guide tracks clean.
3. Make sure that the terminals on the battery and the
battery charger are clean before the battery is put in
the battery charger or the product.
Troubleshooting
Keypad
Keypad Possible faults Possible action
Green LED flashing Low battery voltage. Charge the battery.
Red error LED flashing The power trigger and the start but-
ton are pressed at the same time.
Release the power trigger and the
product becomes active.
Temperature deviation. Let the product cool down.
The product does not start Dirt in battery connectors. Clean with compressed air or a soft
brush.
12 519 - 002 - 30.05.2018