Operators Manual
Table Of Contents
- Symbols on the machine:
- Symbols on the battery and/or on the battery charger:
- Symbols in the operator’s manual:
- Contents
- Note the following before starting:
- Dear Customer,
- General power tool safety warnings
- Personal protective equipment
- Battery and battery charger
- Machine¢s safety equipment
- Battery
- Battery charger
- Transport and storage
- Disposal of the battery, battery charger and machine
- Check before starting
- Connect battery to the machine
- Starting and stopping
- General working instructions
- Inspection and maintenance
- Cleaning and lubrication
- Troubleshooting schedule
- Maintenance schedule
- Technical data
- EC Declaration of Conformity (Applies to Europe only)
GENERAL SAFETY PRECAUTIONS
12 – English
Blade and blade guard
The outer part of the blades (1) is shaped as blade
guards.
Check that the blade guard is not damaged or distorted.
Replace the cutting unit if it is bent or damaged. The term
”power tool” in the warnings refers to your mains-operated
(corded) power tool or battery-operated (cordless) power
tool.
Fitting the end protection on the cutting
deck
The tip protector is used to protect the outer end of the
blade.
• Fit the end protection on the cutting unit.
• Use the screw and the nut on the cutting deck. Tighten
to 8 Nm.
Li-ion
Li-ion
1