Operators Manual
Table Of Contents
- Symbols on the machine:
- Symbols on the battery and/or on the battery charger:
- Symbols in the operator’s manual:
- Contents
- Note the following before starting:
- Dear Customer,
- General power tool safety warnings
- Personal protective equipment
- Battery and battery charger
- Machine¢s safety equipment
- Cutting equipment
- Adjusting the harness
- Battery
- Battery charger
- Transport and storage
- Disposal of the battery, battery charger and machine
- Check before starting
- Connect battery to the machine
- Starting and stopping
- General working instructions
- Stem limbing
- Inspection and maintenance
- Troubleshooting schedule
- Maintenance schedule
- Technical data
- EC Declaration of Conformity (Applies to Europe only)
GENERAL SAFETY PRECAUTIONS
English – 13
• Keep the chain properly tensioned! If the chain is
slack it is more likely to jump off and lead to increased
wear on the bar, chain and drive sprocket.
• Keep cutting equipment well lubricated and
properly maintained! A poorly lubricated chain is
more likely to break and lead to increased wear on the
bar, chain and drive sprocket.
Specification of bar and saw chain
When the cutting attachment supplied with your machine
has to be replaced, because it is worn out or damaged,
you must only fit the types of bar and saw chain
recommended by us.
Guide bar
• Length (inches/cm)
• Chain pitch (inches). The spacing between the drive
links of the chain must match the spacing of the teeth
on the bar tip sprocket and drive sprocket.
• Number of drive links. The number of drive links is
determined by the length of the bar, the chain pitch
and the number of teeth on the bar tip sprocket.
• Bar groove width (inches/mm). The groove in the bar
must match the width of the chain drive links.
• Lubrication hole and hole for the chain tensioner.
Saw chain
• Saw chain pitch (inches). (The distance between
three drive links, divided by two.)
• Drive link width (mm/inches)
!
WARNING! Never use a machine with
faulty safety equipment. The machine's
safety equipment must be checked and
maintained as described in this section.
If your machine fails any of these checks
contact your service agent to get it
repaired.
!
WARNING! Always remove the battery to
prevent the machine being started by
accident. Make sure that the cutting
attachment has stopped completely
before you start to do any work on the
machine.