Operators Manual
Table Of Contents
- Symbols on the machine:
- Symbols on the battery and/or on the battery charger:
- Symbols in the operator’s manual:
- Contents
- Note the following before starting:
- Dear Customer,
- General power tool safety warnings
- Personal protective equipment
- Battery and battery charger
- Machine¢s safety equipment
- Cutting equipment
- Adjusting the harness
- Battery
- Battery charger
- Transport and storage
- Disposal of the battery, battery charger and machine
- Check before starting
- Connect battery to the machine
- Starting and stopping
- General working instructions
- Stem limbing
- Inspection and maintenance
- Troubleshooting schedule
- Maintenance schedule
- Technical data
- EC Declaration of Conformity (Applies to Europe only)
ASSEMBLY
18 – English
Fitting the bar and chain
• Unscrew the bar nut and remove the protective cover.
• Fit the bar over the bar bolt. Place the bar in its
rearmost position. Place the chain over the drive
sprocket and in the groove on the bar. Begin on the top
side of the bar.
• Make sure that the edges of the cutting links are facing
forward on the top edge of the bar.
• Fit the cover and locate the chain adjuster pin (A) in
the hole in the bar. Check that the drive links of the
chain fit correctly on the drive sprocket (B) and that the
chain is in the groove in the bar (C). Tighten the bar
nut finger-tight.
• Tension the chain by turning the chain tensioning
screw clockwise using the combination spanner. The
chain should be tensioned until it does not sag from
the underside of the bar.
• The chain is correctly tensioned when there is no slack
on the underside of the bar, and it can still be turned
easily by hand. Tighten the bar nut with the
combination spanner while holding up the tip of the bar.
When fitting a new chain, the chain tension has to be
checked frequently until the chain is run-in. Check the
chain tension regularly. A correctly tensioned chain
ensures good cutting performance and long life.
Rotating the saw head
• Loosen the lock screw.
• Turn the saw head 90° and secure the head with the
screw.
Assembling the branch hook
Assemble the twig guard with the two screws.
Dismantling the shock guard
• Dismantle the shock guard by unscrewing the screws.
• Assemble the shock guard using the screws.
Li-ion
Li-ion
Li-ion
Li-ion