Operators Manual
Table Of Contents
- Symbols on the machine:
- Symbols on the battery and/or on the battery charger:
- Symbols in the operator’s manual:
- Contents
- Note the following before starting:
- Dear Customer,
- General power tool safety warnings
- Personal protective equipment
- Battery and battery charger
- Machine¢s safety equipment
- Cutting equipment
- Fitting the loop handle
- Fitting the handlebar
- Assembling the guard
- Adjusting the harness and trimmer
- Standard harness
- Transport position, handlebar
- Battery status
- Battery charger
- Transport and storage
- Disposal of the battery, battery charger and machine
- Check before starting
- Connect battery to the machine
- Starting and stopping
- General working instructions
- Inspection and maintenance
- Troubleshooting schedule
- Maintenance schedule
- Technical data
- EC Declaration of Conformity (Applies to Europe only)
ASSEMBLY
14 – English
Standard harness
Quick release
At the front is an easily accessible, quick release. Use this
if the engine catches fire or in any other emergency
situation that requires you to free yourself from the
machine and harness.
Spreading the load on your shoulders
A well-adjusted harness and machine makes work much
easier. Adjust the harness for the best working position.
Tension the side straps so that the weight is evenly
distributed across both shoulders.
Correct height
The machine should be supported in a harness when
trimming so that the cutting equipment is parallel to the
ground.
Correct balance
Let the trimmer head balance at a comfortable cutting
height, i.e. close to the ground.
Transport position, handlebar
• The handlebar can easily be turned to fit along the
shaft for easier transportation and storage.
• Loosen the knob. Turn the handle clockwise so that
the throttle handle touches the battery.
• Now twist the handlebar around the shaft. Tighten the
knob.
Li-ion
Li-ion