Operators Manual
Table Of Contents
- Symbols on the machine:
- Symbols on the battery and/or on the battery charger:
- Symbols in the operator’s manual:
- Contents
- Note the following before starting:
- Dear Customer,
- General power tool safety warnings
- Personal protective equipment
- Battery and battery charger
- Machine¢s safety equipment
- Cutting equipment
- Fitting the loop handle
- Fitting the handlebar
- Assembling the guard
- Adjusting the harness and trimmer
- Standard harness
- Transport position, handlebar
- Battery status
- Battery charger
- Transport and storage
- Disposal of the battery, battery charger and machine
- Check before starting
- Connect battery to the machine
- Starting and stopping
- General working instructions
- Inspection and maintenance
- Troubleshooting schedule
- Maintenance schedule
- Technical data
- EC Declaration of Conformity (Applies to Europe only)
BATTERY HANDLING
English – 15
Battery status
The display shows the battery capacity and if there are
any problems with the battery. The battery capacity is
displayed for 5 seconds after the machine is switched off
or the battery indicator button is pressed. The warning
symbol on the battery is lit when an error has occurred.
See fault codes.
Battery charger
Connect the battery charger
• Connect the battery charger to the voltage and
frequency specified on the rating plate. Put the
electric plug in a earthed socket-outlet. The LED on
the battery charger flashes green once.
• The battery will not be charged if the battery
temperature is over 50
°C. In that case the battery
charger will actively cool down the battery.
Connect the battery to the battery charger
Regularly check that the battery charger and the battery
are intact. See also instructions under the Maintenance
heading.
The battery must be charged before using it the first time.
The battery is only 30% charged when delivered.
• Put the battery in the battery charger. Make sure that
the battery is connected to the battery charger.
• The green charging light on the charger is lit when the
battery is connected to the battery charger.
• When all LEDs are lit the battery is fully charged.
• Pull out the plug. Never jerk the power supply cable to
disconnect it from the wall socket.
• Remove the battery from the battery charger.
Charging status
Lithium-ion batteries can be charged at whatever
charging level. The charging process can be cancelled or
started whatever the battery’s charge level is. The battery
is not damaged. A fully charged battery will not lose its
charge even when the battery is left in the charger.
The battery will not be charged if the battery temperature
is over 50
°C.
LED lights Battery status
All LEDs are lit Fully charged (75-100%).
LED 1, LED 2, LED 3 are
lit.
The battery is 50%-75%
charged.
LED 1, LED 2 are lit.
The battery is 25%-50%
charged.
LED 1 is lit.
The battery is 0%-25%
charged.
LED 1 flashes
The battery is empty.
Charge the battery.
!
WARNING! Risk of electric shock and
short circuiting. Use approved and intact
wall sockets. Make sure that the cable is
not damaged. Replace cable if it appears
to be damaged in any way.
1
2
34
LED display Charging status
LED 1 flashes
The battery is 0%-25%
charged.
LED 1 is lit, LED 2
flashes.
The battery is 25%-50%
charged.
LED 1, LED 2 are lit, LED
3 flashes
The battery is 50%-75%
charged.
LED 1, LED 2, LED 3 are
lit, LED 4 flashes
Battery is 75%-100%
charged
LED 1, LED 2, LED 3,
LED 4 are lit.
When all the LEDs are lit
on the battery, it is fully
charged.
1
2
3
4
1
2
3
4