Operators Manual
Table Of Contents
- Symbols on the machine:
- Symbols on the battery and/or on the battery charger:
- Symbols in the operator’s manual:
- Contents
- Note the following before starting:
- Dear Customer,
- General power tool safety warnings
- Personal protective equipment
- Battery and battery charger
- Machine¢s safety equipment
- Cutting equipment
- Fitting the loop handle
- Fitting the handlebar
- Assembling the guard
- Adjusting the harness and trimmer
- Standard harness
- Transport position, handlebar
- Battery status
- Battery charger
- Transport and storage
- Disposal of the battery, battery charger and machine
- Check before starting
- Connect battery to the machine
- Starting and stopping
- General working instructions
- Inspection and maintenance
- Troubleshooting schedule
- Maintenance schedule
- Technical data
- EC Declaration of Conformity (Applies to Europe only)
22 – English
MAINTENANCE
Troubleshooting schedule
Troubleshooting takes place from the keypad.
Keypad
Troubleshooting the battery and/or the battery charger during charging.
Battery
Battery charger
Control panel Possible faults Possible action
Green activate LED flashing. Low battery voltage. Charging the battery
Error LED flashes.
The power trigger and the activate
button are pressed at the same
time.
Release the power trigger and the
machine is active.
Overload.
The trimmerhead is jammed.
Remove the battery from the
machine. Release the trimmer
head from grass.
Temperature deviation Allow the machine to cool down.
The machine does not run Dirt in battery connectors.
Clean with compressed air or a soft
brush.
Error LED is lit with red light. Service Contact your service agent.
LED display Possible faults Possible action
Green activate LED flashing. Low battery voltage. Charge the battery
Error LED flashing
The battery is discharged. Charge the battery
Temperature deviation
Use the battery in surroundings
where temperatures are between -
10
°C and 40 °C.
Over voltage
Check that the mains voltage
corresponds with that stated on the
rating plate on the machine.
Remove the battery from the
battery charger.
Error LED is lit Cell difference too much (1V) Contact your service agent.
LED display Possible faults Possible action
Error LED flashing Temperature deviation
Use the battery charger only when
the surrounding temperature is
between 5
°C and 40 °C.
Error LED is lit Contact your service agent.