Operators Manual
Table Of Contents
- Symbols on the machine:
- Symbols on the battery and/or on the battery charger:
- Symbols in the operator’s manual:
- Contents
- Note the following before starting:
- Dear Customer,
- General power tool safety warnings
- Personal protective equipment
- Battery and battery charger
- Machine¢s safety equipment
- Cutting equipment
- Fitting the loop handle
- Fitting the handlebar
- Assembling the guard
- Adjusting the harness and trimmer
- Standard harness
- Transport position, handlebar
- Battery status
- Battery charger
- Transport and storage
- Disposal of the battery, battery charger and machine
- Check before starting
- Connect battery to the machine
- Starting and stopping
- General working instructions
- Inspection and maintenance
- Troubleshooting schedule
- Maintenance schedule
- Technical data
- EC Declaration of Conformity (Applies to Europe only)
English – 25
TECHNICAL DATA
EC Declaration of Conformity (Applies to Europe only)
We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare that the battery lawn trimmers
Husqvarna 536LiL, 536LiR with serial numbers dating from 2012 onwards (the year is clearly stated on the rating plate,
followed by the serial number), comply with the requirements of the COUNCIL’S DIRECTIVE:
- of May 17, 2006 ”relating to machinery” 2006/42/EC.
- of December 15, 2004 ”relating to electromagnetic compatibility” 2004/108/EC.
- of May 8, 2000 ”relating to the noise emissions in the environment” 2000/14/EC.
- of December 12, 2006 ”relating to electrical equipment designed for use within certain voltage limits” 2006/95/EC.
- of September 6, 2006 ”on batteries and accumulators and waste batteries and accumulators” 2006/66/EC.
Notified body 0404, SMP Svensk Maskinprovning AB, Box 7035, SE-750 07 Uppsala, Sweden, has performed
conformity assessment according to Annex VI of Directive 2000/14/EC and issued a certificate with the number:
01/1610/002
VDE-Prûf- und Zertifizerungsinstitut GmbH, Meriansstrasse 28, DE-63069 Offenbach (Am Main), Germany, has
performed voluntary type examination on behalf of Husqvarna AB.
For information relating to noise emissions, see the Technical data chapter.
The following standards have been applied:
EN 60335-1, IEC 60335-2-91, EN 62133, EN 60335-2-29, EN ISO 11806
Huskvarna 7 may 2012
Peter Lameli, CTO (Authorized representative for Husqvarna AB and responsible for technical documentation.)