Operating Guide

6 – English
ASSEMBL Y
Fitting the hand guar d and loop
handle
(HA 110)
1 Loosen the clutch sleeve’s two mounting bolts and
dismantle the clutch sleeve.
2 Assemble the hand guard and loop handle by screwing
them together. Take care to align the holes in both parts.
3 Slide the loop handle and hand guard onto the shaft.
4 Slide the spacer into the slot in the loop handle.
5 Fit the nut and screw. Do not overtighten.
6 Now make a final adjustment to give yourself a
comfortable working position. Tighten the screw.
CAUTION! The loop handle and hand guard must not be
fitted behind the arrow marked on the shaft.
7 Fit the clutch sleeve and tighten the two mounting bolts.
Fitting the cutting head
It is impor tant that the hedge trimmer is laid on a flat surface
when you fit the cutting head. Otherwise the cutting head may
not be fitted straight.
1 Fit the cutting head to the shaft. CAUTION! Make sure the
drive shaft inside the shaft engages with the recess in the
cutting head.
2 Tighten the lower screw first, then the upper screw.
Fitting the handle
(HA 850)
Fit the handle using tw o screws.