Operators Manual
ASSEMBLY
40 – English
in the opposite direction to the direction of rotation
(Caution! left-hand thread).
Fitting the trimmer guard and trimmer
head
• Fit the correct trimmer guard (A) for use with the
trimmer head. CAUTION! Ensure that the guard
extension is fitted.
• Hook the trimmer guard/combination guard onto the
fitting on the shaft and secure with the bolt (L).
• Fit the drive disc (B) on the output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
• To dismantle, follow the instructions in the reverse
order.
Fitting the transport guard
• Insert the blade in the transport guard (A).
• Snap the two fasteners (B) into the slots (C) to secure
the transport guard.
Adjusting the harness and brush
cutter
Adjusting the backplate height
• Loosen the two fasteners holding the backplate.
• Loosen the backplate from the frame on one side.
G
E
D
F
B
C
B
A
M
L
H
A
L
C
M
H
H
H1155319-26,543RBS.fm Page 40 Wednesday, June 24, 2015 10:20 AM