Operators Manual
ASSEMBLY
English – 41
• Move the backplate to the desired height and fasten it.
Make sure the pin aligns with one of the holes on the
frame, see picture.
Adjusting the harness
• Put on the harness.
• Tighten the waist strap so that it sits securely.
• Tighten the chest strap.
• Adjust the chest strap vertically if needed and make
sure it fits well.
• Adjust the shoulder straps to distribute the load evenly
across your shoulders.
• Loosen or tighten the waist strap so that approx. 70%
of the load is on your waist and 30% on your
shoulders.
Assembling and dismantling the
two-piece shaft
Assembly
• Loosen the coupling by turning the knob
anticlockwise.
• Align the tab of the attachment (A) with the arrow on
the coupling (B).
• Push the attachment into the coupling until the
attachment snaps into place.
• Before using the unit, tighten the knob securely.
A
B
H1155319-26,543RBS.fm Page 41 Wednesday, June 24, 2015 10:20 AM