Operators Manual

1. Select Settings > Operation in the app.
2. Select On/Off to enable or disable Spiral
cutting .
3. Select
Settings > Spiral Cutting > Use >
Intensity to select the level of the function.
4. Select Save .
3.11.2.2 Weather timer
The
Weather timer automatically adjust the
cutting time to the growth of the grass. The
product is not permitted to operate more than the
schedule settings.
Note: When using Weather timer , it is
recommended to make as much operating time
as possible available for the Weather timer . Do
not restrict the schedule more than necessary.
The first operation of the day is set by the
schedule settings. The product always complete
1 mowing cycle, and then the
Weather timer
selects if the product will continue to operate or
not.
Note: The Weather timer is reset if the product
does not operate for more than 50 hours, or if a
Reset of all user settings is done. The Weather
timer
is not changed if a Reset of schedule
settings is done.
To set the Weather timer
1. Select Settings > Operation in the app.
2. Select
on/off to enable or disable the
Weather timer .
Note:
If the cutting results are not
satisfactory, the cutting time can be
adjusted. Set the cutting time
High to cut for
a longer time or
Low to cut for a shorter
time.
3. Select
Save .
3.11.2.3 ECO mode
If ECO mode is activated, it switches off the
signal in the boundary loop, the guide wire and
the charging station, when the product is parked
or is charging.
Note:
Use
ECO mode to save energy and avoid
interference with other equipment, for example
hearing loops or garage doors.
Note: To start the product manually in the work
area, push the STOP button before you remove
the product from the charging station. If not, the
product can not be started in the work area.
To set the ECO mode
1. Select Settings > Operation in the app.
2. Select on/off to enable or disable the ECO
mode
function.
3. Select Save .
3.11.3 Installation
In the Installation menu it is possible to
adapt the settings of the product for
best mowing result.
3.11.3.1 To find the charging station
The product can be set to search for the charging
station in 3 methods:
• Charging station signal
• Follow boundary wire
• Follow guide wire
The factory setting is set to use the 3 search
methods at the same time. Use the factory
setting to find the charging station as fast as
possible and to keep the risk of tracks on the
lawn to a minimum. The product always starts to
search for the
Charging station signal . After a
specified time interval, it also uses
Follow guide
and Follow boundary wire .
Causes why the product cannot follow the wire:
• Obstacles near the wire have not been
isolated.
• The charging station, the boundary wire or
the guide wire are not installed according to
the instructions in
To install the charging
station on page 20
, To install the boundary
wire on page 21 and in To install the guide
wire on page 22
.
To change the signal range of the charging
station
For some installations it is necessary to decrease
the signal of the charging station. For example
1439 - 002 -
Installation - 27