Operators Manual

when the charging station is put near an obstacle
such as a bush or wall and the signal reaches to
the other side of the obstacle. The product knows
that it is close to the charging station and tries to
dock, but the objects prevents it. The options are
min , avg (average) or max .
Note: It is usually better to move the charging
station, than to decrease the range of the
charging station signal.
1. Select Settings > Installation > Find charging
station
in the app.
2. Select signal range.
3. Select
Save .
To set the delay time for the guide wire and the
boundary wire
1. Select Settings > Installation > Find charging
station
in the app.
2. Select on/off to enable or disable to follow
the wire.
3. Move the horizontal bar to set the time
delay.
4. Select
Save .
3.11.3.2 Lawn coverage
The product has GPS Assisted Navigation that
helps the product select the most optimal
operation.
Use the Lawn coverage function to set the
settings to manual.
To set the GPS function
1. Select
Installation > Settings > Lawn
coverage in the app.
2. Select on/off to disable or enable the GPS
function.
Note:
When GPS assisted navigation is
enabled it is used while there is a GPS
service. The GPS assisted navigation is
used even if manual settings have been
made. Only when GPS service is not
available, the manual settings are used.
3. Select Save .
To set the Lawn Coverage function
The Lawn Coverage function is used to guide the
product to remote parts of the work area. If the
work area includes remote parts that are
connected with narrow passages, the
Lawn
Coverage function is useful to to keep a well-cut
lawn in all parts of the yard. You can set a
maximum of 5 remote areas where the product
starts to cut the lawn.
Each area can be enabled or disabled, without
having to enter the settings again.
1. Select
Settings > Installation > Lawn
coverage in the app.
2. Select
on/off to disable the GPS function to
set the Lawn Coverage .
3. Select on/off Area 1-5 to activate the area.
4. Move the horizontal bar to set which wire the
product will follow. The product can follow
Boundary wire left , Boundary wire right or
one of the guide wires.
5. Move the horizontal bar to set the distance
the product must follow the wire. The
product then leaves the wire and starts to
cut the lawn. Refer to
To measure the
distance from the charging station on page
28 .
6. Move the horizontal bar to set how often the
product goes to each area. At all other
times, the products starts to cut near the
charging station. The percentage is equal to
the percentage of the area in relation to the
complete work area.
a) Measure the area.
b) Divide the area with the complete work
area.
c) Convert the result to %.
d) Move the horizontal bar to set the
distance from the charging station.
7. Select
Save .
The default settings lets the product follow the
guide wire m / ft. in of the times it leaves the
charging station. If the guide wire is less than m /
ft. the product will follow it to the point where the
guide wire is connected to the boundary wire.
To measure the distance from the charging
station
1. Put the product in the charging station.
2. Select
Settings > Installation > Lawn
coverage
in the app.
3. Move the horizontal bar to set the distance
to the charging station to maximum.
28
- Installation
1439 - 002 -