Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Installation
- Introduction - Installation
- Main components for installation
- General preparations
- Before the installation of the wires
- Installation of the product
- To put the wire into position with stakes
- To bury the boundary wire or the guide wire
- To extend the boundary wire or the guide wire
- After the installation of the product
- Automower® Connect
- Settings in Automower® Connect
- Operation
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Warranty
- EC Declaration of Conformity
Message Cause Action
No loop signal
The power supply or the low-voltage
cable is not connected.
Examine the LED status on the charg-
ing station. If there is no power to the
charging station, the LED is not lit. Ex-
amine the wall socket connection and if
a residual-current device is engaged.
Make sure that the low-voltage cable is
connected to the charging station.
The power supply or the low-voltage
cable is damaged.
Replace the power supply or low-volt-
age cable.
The boundary wire is not connected to
the charging station.
Make sure that the boundary wire con-
nectors are fitted properly to the charg-
ing station. Replace connectors if dam-
aged. Refer to
To install the boundary
wire on page 21
.
Boundary wire broken. Examine the LED on the charging sta-
tion. If the LED indicates that there is a
break in the boundary wire, find out
where the break is. Replace the dam-
aged section of the loop with a new
loop wire. Use an original coupler to
make a splice of the loop ends. Refer
to
Finding breaks in the loop wire on
page 51
.
ECO mode
is activated and the product
has attempted to start outside the
charging station.
Put the product in the charging station.
Start the product and close the hatch.
Refer to
Start on page 33
.
The boundary wire is crossed on its
way to and from an island.
Make sure that the boundary wire is put
down correctly. Refer to
To examine
where to put the boundary wire on
page 16
.
The product does not find the loop sig-
nal from the charging station.
Put the product in the charging station
and generate a new loop signal. Refer
to
New loop signal on page 30
.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles close by.
Try to move the boundary wire and/or
make more islands in the work area to
increase the signal strength.
Wrong PIN code
An incorrect PIN code has been en-
tered. 5 tries are permitted, and the
product is then blocked for a period of
time.
Enter the correct PIN code. Contact
your local Husqvarna representative if
you forget the PIN code.
40 - Troubleshooting
1439 - 002 -