Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Installation
- Introduction - Installation
- Main components for installation
- General preparations
- Before the installation of the wires
- Installation of the product
- To put the wire into position with stakes
- To bury the boundary wire or the guide wire
- To extend the boundary wire or the guide wire
- After the installation of the product
- Automower® Connect
- Settings in Automower® Connect
- Operation
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Warranty
- EC Declaration of Conformity
Message Cause Action
Alarm! Mower
switched off
The alarm was activated because the
product was switched OFF.
Adjust the mower security settings in
the
Security
menu. Refer to
Security
(Bluetooth
®
only) on page 30
.
Alarm! Mower
stopped
The alarm was activated because the
product was stopped.
Alarm! Mower lif-
ted
The alarm was activated because the
product was lifted.
Alarm! Mower til-
ted
The alarm was activated because the
product was tilted.
The product is tilted more than the
maximum angle.
Move the product to a flat area.
Electronic problem
Temporary electronic or firmware rela-
ted issue in the product.
Restart the product.
If the problem stays, speak to your ap-
proved servicing dealer.
Loop sensor prob-
lem, front/rear
Charging system
problem
Tilt sensor prob-
lem
Temporary prob-
lem
Wheel drive prob-
lem, right/left
Invalid device
combination
Ultrasonic problem
GPS navigation
problem
Temporary battery
problem
Faulty mix of bat-
teries
Battery problem
Temporary battery or firmware related
issue in the product.
Restart the product.
If the problem stays, speak to your ap-
proved servicing dealer..
Wrong type of battery Use only original batteries recommen-
ded by the manufacturer.
1439 - 002 - Troubleshooting - 43