Operators Manual

Message Cause Action
Guide 1 not found
Guide 2 not found
Guide 3 not found
The guide wire is not connected to the
charging station.
Check that the guide wire’s connector
is tightly connected to the charging sta-
tion. Refer to To install the guide wire
on page 22 .
Break in the guide wire. Find out where the break is. Replace
the damaged section of the guide wire
with a new loop wire and splice using
an original coupler.
The guide wire is not connected to the
boundary loop.
Check that the guide wire is connected
correctly to the boundary loop. Refer to
To install the guide wire on page 22 .
Guide calibration
failed
The product has failed to calibrate the
guide wire.
Check that the guide wires are installed
according to the instructions. Refer to
To install the guide wire on page 22 .
The next time the product moves out
from the charging station, a new guide
calibration is done.
Guide calibration
accomplished
The product has succeeded to calibrate
the guide wire.
No action required.
GPS navigation
problem
Problem with the GPS assisted naviga-
tion equipment.
Contact your local Husqvarna repre-
sentative if this message appears of-
ten.
Weak GPS signal The sky is blocked in large parts of the
work area.
If possible, remove objects that can
cause a blockage of the GPS signal.
Disable the GPS navigation function
and use the lawn coverage function.
Refer to Lawn coverage on page 28 .
Difficult finding
home
The product has been following the
boundary wire several laps without find-
ing the charging station.
The installation has not been done cor-
rectly. Refer to Installation on page 15 .
Wrong corridor width setting on boun-
dary wire. Refer to Corridor width on
page 29 .
The product was started on a Secon-
dary area with the Main area setting.
Temporary prob-
lem with the serv-
er.
Please try again. Contact your local Husqvarna repre-
sentative if this message appears of-
ten.
Connection prob-
lems
Problem with the Automower
®
Connect
module
Restart the product. If there still is a
connection problem, try to unpair the
product (My mowers) and then pair it
again. If the problem remains, contact
your local Husqvarna representative.
46 - Troubleshooting
1439 - 002 -