Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Installation
- Introduction - Installation
- Main components for installation
- General preparations
- Before the installation of the wires
- Installation of the product
- To put the wire into position with stakes
- To bury the boundary wire or the guide wire
- To extend the boundary wire or the guide wire
- After the installation of the product
- Automower® Connect
- Settings in Automower® Connect
- Operation
- Maintenance
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Warranty
- EC Declaration of Conformity
Message Cause Action
Connection set-
tings restored
Settings for wireless connectivity have
been restored due to an error.
Check and revise settings if necessary.
SIM card requires
PIN
The SIM card must be unlocked. Make sure the correct SIM PIN has
been entered into the mower's menu
(Network > SIM card). Contact your lo-
cal Husqvarna representative if this
message appears often.
SIM card locked
The SIM card must be replaced. Contact your local Husqvarna repre-
sentative.
SIM card not found
Automower
®
Connect requires a SIM
card to be inserted in the mower.
Contact your local Husqvarna repre-
sentative.
GeoFence prob-
lem
The GeoFence is not work due to poor
(or no) communication with the system.
Contact your local Husqvarna repre-
sentative.
6.4 LED indicator lamp on the charging station
For a fully functional installation, the indicator lamp in the charging station must emit a solid or flashing
green light. If any other color than green is visible, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, please contact your local Husqvarna
representative.
Light Cause Action
Green solid light
Good signals No action required
Green flashing
light
The signals are good and
ECO mode
is
activated.
No action required. For more informa-
tion on
ECO mode
. Refer to
ECO mode
on page 27
.
Blue flashing light
The boundary loop is not connected to
the charging station.
Check that the boundary wire connec-
tors are fitted properly to the charging
station. Refer to
To install the boundary
wire on page 21
.
Break in the boundary loop. Find out where the break is. Replace
the damaged section of the loop with a
new loop wire and splice using an origi-
nal coupler.
Red flashing light
Interruption in the charging station’s an-
tenna.
Contact your local Husqvarna repre-
sentative.
Red solid light
Fault in the circuit board or incorrect
power supply in the charging station.
The fault should be rectified by an au-
thorized service technician.
Contact your local Husqvarna repre-
sentative.
1439 - 002 - Troubleshooting - 47